• 86-15850596034
  • feiyuedigitalinc@gmail.com

What is the scraper method and the swing knife technique on the printing machine?

What is the scraper method and the swing knife technique on the printing machine?

When cutting the knife on the head of the printing locomotive, two hands should hold the knife, and the knife edge will move up. Put it on the tray first, then lift the knife edge up and put it in the knife pot. Be careful not to hurt or damage the knife edge. As for the skill of putting the knife, it is only a general description of the printing machine because of the difference between the machine and the flower pattern. Printing machine to determine the height of the knife, that is, the angle of the size of the factors, should be based on the depth of carving, color paste properties, soft and hard blades, blade thickness, pressure size and other factors considered comprehensively, the knife placed high, small angle; the knife placed low, large angle.

1. Lines, moire, snowflakes, flower tips, dry pens and other knives should be lowered, and the hammer should be slightly heavier.

2. Flowers, full ground and other flower knives should be higher, and the hammer should be lighter.

3. The diagonal knife with horizontal bar and horizontal grid should be laid out a little more obliquely. The obliquity direction should be opposite to the oblique direction of the pattern, about l2.7rmn (1/2 inch), but also higher.

4. Easy-to-scrape color paste, thin paste, long-term use of the flower tube, carved lighter flower tube, the knife should be placed higher.

Today’s article is shared here, if you are interested in our products, you can click on the link to buy. If you have any questions about the sublimation printing, please leave a message below, we will reply as soon as possible, thank you for browsing.

admin

Leave your message