The sublimation roller transfer machine is not limited to fabrics, whether it is cotton or polyester, spandex and other chemical fiber materials, or chemical fiber and cotton mixture, as well as denim, linen, etc., can be directly printed. Whether it is white fabric, light fabric, or dark fabric, you can print a variety of colorful patterns.
When the roller printing machine is in operation, it encounters a relatively serious phenomenon. Do we need to stop the roller printing machine?
1. The intarsia tube is serious and should not be removed with a brush.
2. The roller of the roller printing machine is criticized. The flower cylinder should be removed and sent to the engraving workshop for repair.
3. If the roller printing machine handles the fault for a long time, the guide cloth or the guide belt should be connected. And the steaming valve should be closed in time to relieve the pressure of the flower cylinder.
4. When the amount of flower print is too much, the pattern is ground and covered with a scraper. After stopping, the flower tube should be removed and sent to the engraving workshop for repair or replacement of the new flower tube.
5. If the color paste is mixed with impurities or the color paste is too thick or too thin, if it does not meet the requirements for use, it should be stopped to pour the color paste back into the pulp tank, and then adjusted and reused after filtration.
6. When the fabric is printed, the head is broken due to poor seam or excessive tension. Even if the cloth head is wrapped around other parts, a major accident will occur and should be stopped immediately.
7. The squeegee has a gap or the knives become dull, which may cause a strip of flowers or cause the squeegee on the surface of the flower tube to be unclean and the outline of the pattern is rough. It is necessary to stop and remove the squeegee for honing.
8. When the tube bearing is damaged during operation and generates heat, when the motor load is increased, do not use cold water to pour the bearing. Stop immediately, replace the good tube bearing, and add the grease to the well.
9. When the rubber bearing roller is aged or cracked or the hardness is increased, the printing effect should be stopped, the flower cylinder should be stopped. And the special grinding and pressing roller equipment should be installed to grind the rubber bearing roller skin to a layer.
10. When the surface of the rubber pressure roller is pressed into a pit by hard objects, it will cause some printing to be unclear. It should be immediately stopped and filled with raw rubber to repair it: when the pit is shallow, the hot water can be used to make the pit.
11. When the drum printing machine is used for a long time, the inner hole will be enlarged. Causing the hub axis and the flower tube to loosen and the flower is not correct. At this time, the flower tube should be removed, the kraft paper strip should be placed. And the kraft paper strip should be re-tightened.
If you meet those phenomenon, you need stop the rotary heat press machine. If you have any other needs or questions welcome to contact us at any time. We will provide you the best quality product and service. Hope my article can be useful to you. Thank you for your reading.