• 86-15850596034
  • feiyuedigitalinc@gmail.com

How To Install The Blanket Of Heat Transfer Printing Machine?

heat press machine

How To Install The Blanket Of Heat Transfer Printing Machine?

Roller heat transfer machine will be worn out due to the loss of the felt during the production process. When the felt is replaced, the original felt cannot be used. Because the felt is directly mounted on the surface of the drum, if the quality of the felt is not good, it will directly affect the normal operation of the roller heat transfer machine. Today, we’re going to share the install steps of blanket of roller heat transfer machine.

roller heat transfer machine

The adjustment of the felt offset is the latter process of the overhaul process. It mainly includes the following tasks: quality inspection and acceptance of the blanket; whether the blanket is stable during operation. After installation, the blanket is not shaped and will not go wrong. Here’re the following two methods to install the rotary heat transfer machine:

1. Fix the felt on the surface of the drum, pass the shaft through the blanket, clamp it in the fixing groove of the felt, rotate the elastic tight loop of the felt, adjust the looseness of the felt so that the bottom can pass through the other shaft, then tighten the screw and fix it. Mechanical shaft, view the width of both sides of the blanket.

2. The machine must be level during the blanket installation process. The machine horizontal method can use the other end of the base bolts 1 and 2 to place the required height plates, such as h, b2, b3 and b4. Then level with the level on the upper surface of the base. When the stand is level in both the vertical and horizontal directions, tighten the anchor bolts 1 and 2. Then add the pad on both the anchor bolt 3 and the reading, and level it in the same way. After leveling, tighten the foot | bolts 3 and 4, and the base is installed. This method is a three-point leveling installation method at the construction site S.

After the machine blanket is installed, it is usually a test machine. The new blanket will have a slight deviation. After several times of setting, it will be fine. If you still don’t know how to install, it is best to find a professional engineer to install.

rotary heat transfer machine

Okay, these all above are my share about the steps of installing the roll heat transfer machine. Hope my article can be useful to you. If you have any other needs or questions welcome to contact us at any time. We will provide you the best quality product and service. Thanks for your reading.


Leave your message