• 86-025-83228894
  • feiyuedigitalinc@gmail.com

How to Adjust the Blanket of Rotary Drum Transfer Machine?

How to Adjust the Blanket of Rotary Drum Transfer Machine?

The blanket of rotary drum transfer machine has generally been adjusted before leaving the factory. Because the blankets work at a high temperature of 250 °C, the cooling machine and the hot blanket have the phenomenon of heat expansion and cold shrinkage. Therefore, the deviation occurs at the beginning of printing.

rotary drum transfer machine

1. During normal transfer, the blanket goes left, but can be turned back. At this time, the blanket goes right and stops at the side of the roller. Tighten the adjustment screw at the left end of the lower tension shaft (4) and loosen the adjustment screw at the right end of the lower tension shaft .
2. If the blanket is still going to the left after rectifying the deviation by using the above method, turn the high speed joint screw at the right end of the upper tension shaft and push forward 5-8mm
3. The blanket of calender heat press to the right, can drive the car back when the blanket to the left side of the big cylinder to stop, properly tighten the lower tension shaft (right side of the adjustment screw), after appropriate screw loose the lower tension shaft (left side of the adjustment screw) can be.
4. After rectifying the deviation with the above method, if the blanket of rotary drum transfer machine is still going to the right at this time, please turn the adjusting screw at the left end of the tension shaft and push forward 5-8mm.

rotary heat press machine Please refer to the following drawings for adjusting the position of the direction.
When debugging the rotary heat transfer machine, please learn from the debugging staff how to correct deviation. If the blanket runs out of place, please call the factory for advice.
Matters needing attention
calender heat press machine 1. In the normal transfer printing if encountered need to transfer the content is not ready, you can turn down the speed appropriately, it is best not to stop, lest the color deviation is too large, do not reverse, so as not to appear shadow.
2. After the use of the rotary drum transfer machine, the machine should still be in a rotating state, because the temperature is still very high after the use of the machine, and the service life of the blanket may be damaged after the shutdown, so the general power supply can only be turned off if the temperature is kept within a safe range.
3. If there is a power failure during the transfer printing, you should turn the hand wheel, so as to remove the blanket from the roller. The most important thing is to cool down the temperature. It is estimated that the rotation can only stop when the temperature drops to a safe range.
4. The machine at high speed operation, not positive and negative gear swap, so as not to burn out the fuse, can only be in the rotation speed to reduce the positive and negative gear swap.

I hope this article will help you. Any question, please contact us. Thank you for your reading.

admin

Leave your message